Let’s all admit it. Plastering walls has never been easy, since it requires a lot of time to dry it all out. Good thing we no longer have to use it since drywall is easier to install and handle. Though it can only withstand limited abuse, as long as you secure them to the joists, it shouldn’t be that much of a problem.
For a successful drywall repairHow You Can Remove Drywall Texture. Read more ... », you will need the following toolsHaving The Correct Home Improvement Tools Speeds Drywall Installation And Finishing. Read more ... » and materials:
-Wide blade taping knivesA Short Introduction To Pocket Knives. Read more ... »
-Drywall screws or nails
-Drywall mesh tape
First thing to do is measure and outline the holeHow To Fix Carpet Burn Damage. Read more ... », extending at least an inch or two on all sides. Check if there are studs installed on each end to provide support for the new patchHow To Fix Carpet Burn Damage. Read more ... ». It may take a while to finish the drywall if you have an irregularly-shaped hole.
Reach inside the hole if there are any obstructions behind the panel. To remove the damaged area, use a utility knife to run it over the lines. You may have to repeat this step until the drywall is completely detached. Do not forget to remove the torn paper edges before you proceed.
Use a scrap wood as a support for the new drywall patch. Cut it a bit longer then the opening and attach them with drywall screws. Make sure the nail heads are below the surface to avoid applying multiple layers of compound when finishing the panel.
Fit the drywall panel inside the hole and screw each side to the joists and back framing. Avoid causing your drywall to crumble by attaching nails far from the edges. Again, make sure the nail heads are below the surface.
Seal the gap in between by taping all the seams with a mesh tape. To prevent having a bubbled tape effect, press the fiberglass tape evenly and smooth it out on the edges. Use a spackling compound to cover the tape pieces and let it dry. Once dry, cover the entire panel with spackling compound and feather out the edges. Leave it for a couple of hours and sand the panel lightly to remove the bumps and beads.
See how easy it is? Knowing how to patch drywall holes should not be a problem as long as you’re willing to get your hands dirty for this messy task. If you don’t have the time to do it on your own, you can always hire a specialist for professional help.